Hunter Norris

Plano, TX

October 11, 2024

DSS installed a DMP XT50 Intrusion Detection Panel in the IT room and connected it to the network as well as installed door contacts at the two front doors. The existing warehouse alarm devices were tested and connected to the panel with wireless transmitters. Any devices that weren't working were replaced. A wireless keypad and one motion detector was installed in the warehouse. We also installed a 360 motion detector in the office area and a keypad inside the reception area door.

Colleyville, TX

September 30, 2024

We installed the access control panel equipment in the equipment room, terminated all of the wiring from the doors, added it to the network, programmed and tested system upon completion.

Fort Worth, TX

September 25, 2024

We installed an IP Network Video Recorder (NVR) in the IT room and connected the new cameras to it. The four new megapixel IP cameras were installed in place of the existing IP cameras. DSS also programmed the cameras, NVR and trained personnel on how to use the system.

Dallas, TX

June 25, 2024

Dallas Security Systems, Inc. provided an intrusion alarm system including a control panel, one keypad and one siren. We also took over the existing alarm system devices (motion detectors, duress buttons, etc.). DMP full APP was provided for the monitoring. We also upgraded existing card reader system for (4) doors, took over existing card reader setup devices and cabling, including release buttons. We successfully resolved the interface issues with the client’s network, enabling browser-based remote control and programming.

Dallas, TX

April 22, 2024

We added (1) intercom to the garage in building #2. An intercom cable was run to the luxul switch located on the 1st floor inside the fire control room. At the end of the job, we verified with the security guard that he was able to both receive calls/video and dial out to the station itself for call/video.

Lewisville, TX

February 8, 2024

The client needed access control and camera systems for a new facility. DSS installed new systems with (5) Brivo readers & (1) ACS6100R-E panel, (4) HES electric door strikes and panic hardware, Honeywell exit devices, (7) Eagle Eye 4MP cameras with CMVR520 for up to 50 cameras. TRENDnet 24 port CAT6 panel, Battery back-up, mobile credentials and Brivo & Eagle Eye Cloud services.

Grapevine, TX

February 5, 2024

Provided and installed a new Boon Edam Turnlock 100 Turnstile (Black Powder Coat) with WinDSX Access Control entering into client's suite.  The card reader will control ingress and unit allows free egress/exit. Card reader mounting boxes: Included for entry & exit (2 total).

Frisco, TX

January 25, 2024

DSS installed a BRIVO ACS6100 system with (2) control panels plus expansion board for (17) card reader access locations in management office and amenity complex at the residential community. Brivo Cloud service was also set up, tested and customer trained how to use the Cloud service and system.

Denton, TX

January 10, 2024

Interfaced the existing receiver to the DSX Access Control System to monitor the panic buttons and readers. Install the new DSX 1042 & 1048 Controllers to the existing system.  Added and grouped the new locations to the hospitals main location on Win DSX Database with existing card holders.  Programed each device with the door naming scheme provided.  Wired each door into the device, program and test accordingly to meet the hospital's requirements.   Also setup (2) WinDSX workstations at the facility for making badges.  

Carrollton, TX

December 21, 2023

Dallas Security Systems replaced existing DMP-XT50 panel with a new DMP-XR150 panel as there are not enough zones available to cover the entire space on the exiting panel. Installed a 16-point zone expander above exterior door and connect all existing devices and a wireless repeater in the same location. Also installed a wireless door contact on the exterior door to the office. DSS connected all new and existing devices and zone expanders to new panel. DSS to programed devices to the panel and tested. Required 2 men and a scissor lift for install.

Westlake, TX

December 21, 2023

Install (2) new Uniview 4MP turret cameras in the classrooms and connect to existing Avigilon server. Focus and program cameras to record video & audio. One classroom already had a camera that we replaced.

Fort Worth, TX

December 8, 2023

Installed new pedestal box on existing pedestal.  Install new card reader/ keypad and intercoms on all 5 gate pedestals.   Programmed changes on the DSX panel per customer requirements. Tested gate reader/keypads.