Weslee Duckworth

Dallas, TX

July 10, 2024

Dallas Security Systems, Inc. wired in all zones from existing panel, programmed, and tested system. We also replaced the 3 pull-apart contacts on overhead doors with rail mount and the motion detector over the front entry and the keypad. Afterwards, we trained our customer on the DMP keypad and app control. The customer's business is also receiving monitoring.

Plano, TX

July 8, 2024

DSS installed 24 doors of access control and connected them to the DSX system in the IT room. There were two double magnetic locks and six strikes. DSS connected to the transfer hinge on these doors. We also installed hardware for doors that are connecting to the DSX access control system.

Irving, TX

June 26, 2024

Dallas Security Systems, Inc. replaced (15) existing analog cameras with IP cameras. Installed new Cat6 cable from cameras to POE switch. Programmed and adjusted view. Installed new pole in parking area above garage down ramp and ran cabling down into security room to switch. We also installed (2) cameras on pole to cover parking lot. Programmed all cameras to record on motion. After job was completed, we trained customer on UniView software and app.

Garland, TX

June 20, 2024

We successfully installed new cabling along red iron back to server room for all cameras. DSS installed NVR, monitor, and switches inside server room and connected all cameras. DSS programmed the NVR, and cameras for motion recording @ 12fps. After the job was completed, we trained the customer on how to use the software and app to view cameras.

Dallas, TX

June 11, 2024

We installed a DSX system with HID card readers and electronic locks.

McKinney, TX

May 7, 2024

Dallas Security Systems, Inc. removed existing access control panel and installed a new Sicunet panel. We wired in existing devices, programmed, and tested system to make sure all devices function properly. We replaced existing maglock with a new one. Upon completion of the job, we trained customer on the new Sicunet system.

Forest Hill, TX

March 28, 2024

We successfully completed a takeover of 28 existing card reader setup. Re-using existing card reader/electronic lock setup. We also installed new cabling to the back network room. Installation of new head-end Brivo cloud hosted access control panels and monitoring were also supplied to customer.

Plano, TX

March 14, 2024

DSS submitted a permit application to the City of Plano to install door release for main door. All devices were installed and tested after permit approval. Brivo cloud controller was installed in IDF room and cabling was ran to the Lobby door. We also installed a card reader, strike, door contact, and REX motion on door. A wireless release button was placed at front desk to unlock lobby door. Upon completion of the job, we trained the customer on the Brivo software and app. 

Haltom City, TX

February 13, 2024

DSS Pulled new cat 6 cabling to two (2) new 6-50mm bullet cameras and mounted on the face of the building. Adjusted for best view possible.  Also installed a new Digital Watchdog Turret Camera in kitchen. Connect the cameras to the DW System, aim, focus and test.

Plano, TX

February 13, 2024

This is a current client who wanted access control updated & added to multiple areas and gates. DSS obtained City permit approval before work and final inspection of updated system and all equipment. Demoed old and installed new Brivo access control system with card readers at (8) locations, doors and (2) inside/(2) outside gates. Doors included crash bars and panic buttons.

Wylie, TX

January 31, 2024

DSS ran wire, conduit and installed (1) Digital Watchdog 4MP IP turret and (1) DW 4K IP dome cameras. Also reconfigured existing interior cameras to the DW server for remote access.

McKinney, TX

January 30, 2024

DSS wired and installed (5) Avigilon 12MP Fisheye dome cameras and network switches on Avigilon enterprise license and connected all to the network.

Allen, TX

January 24, 2024

DSS submitted permit application to City of Allen for installing Dynalock maglock, Honeywell exit motion, and Camden exit button on 2 main doors. All devices installed and tested after permit approval. Fire alarm was also connected directly to DSX panel and tested. An Alarm Controls wireless release/panic button was also installed for remote access.

Flower Mound, TX

January 22, 2024

DSS obtained the permit with the City and lift rental before work could begin. DSS coordinated with GC to install AMAG access control system throughout business. Install included card readers, electric strikes, exit motions and door contacts on three (3) interior doors and connected to the AMAG panel. Also connected three (3) exterior doors with siren if left open and one (1) with push paddle. All cable was run and each device connected to panel and tested.

Keller, TX

January 16, 2024

DSS installed (56) Uniview Camera Systems in designated areas at two locations and connected to 64 channel 40TB NVR server with a 32" HD monitor. Camera types include 4K - turret, fisheye dome, and bullet style. Custom field-of views adjusted with variable focus length lens for all cameras. Set-up system and tested.

Irving, TX

January 9, 2024

Installed twenty (20) Mullion mount tri-technology card readers. Compatible with Brivo Mobile Pass bluetooth credentials. Provide ongoing cloud services. Job permit drawings approved by city.

Addison, TX

December 20, 2023

Pulled CAT6 cabling from new Avigilon 2.0C H5A D1 indoor dome camera location to POE switches. Installed new dome camera in hallway. Added camera license to the Avigilon server. Added new dome camera to ACC7 software, programmed, adjusted view and tested. Took pictures of network rack, camera view, IP location and switch and saved to project.

Fate, TX

December 20, 2023

A Securitron entry system with access control keypad was installed at 2 entry doors. After install system was programmed, tested and customer was trained how to use the system. A month later, at the same location, DSS was hired to demo the existing control panel and reroute and run wire to install and program a new Sicunet access panel.

Sunnyvale, TX

December 20, 2023

DSS wired and installed fully functional alarm system with a DMP XR150 panel connected to all man doors, office and warehouse doors. Along with detection hardware for glass break, 360 degree motion, long range motions and long range photo beam set.

Ovilla, TX

December 12, 2023

DSS ran cable and connected existing card reader and added a new Fairpointe Access mobile ready card reader. Installed mag-locks & exit button at dbl. doors. Connected all equipment to Sicunet control panel and tested.

Cedar Hill, TX

December 5, 2023

Installed control panels and ran cabling to the shop and office access doors and installed HES-5200C failsafe/secure strike devices. Wired door into control panel. Tested doors after programming. 

Lancaster, TX

December 5, 2023

DSS pulled CAT5 to replace the existing system with a Brivo Access Control System. Including (2) BSPMF-B Tri-tech readers & (1) BSPKF-B reader with keypad, all compatible with Brivo Mobile Pass, Alt. power supply and Wi-Fi door controllers.